Is your Realme 12 5G stuck on a black screen, bootloop, lock, or FRP Lock screen & want to use UFI or Easy JTAG Box to fix it? Then, the Realme 12 5G UFS ISP Pinout Test Point can help you easily enable memory-level flashing, unlock, and repair the phone.
What is ISP (In-System Programming)?
ISP mode is a protocol that helps you to access the EMMC or UFS chips without removing them from the PCB. You just need to find the pinout on the motherboard and connect it using a compatible EMMC tool like UFI, Easy JTAG, or Medusa Pro.
Also read: Xiaomi MI 2s EDL Mode (Test Point)
The ISP pinout enables you to fix EDL not working, black screen, no boot, no charging, FRP lock remove, Erase partition reprogram the UFS or EMMC, Flash Dump Firmware, Unlock Screen & User area, etc.
Read: Samsung A71 5G Hard Reset
Realme 12 5G UFS ISP Pinout Test Point Image
Prerequisites:
- Install the Qualcomm USB driver on Windows.
- UFI, Easy JTAG, or Medusa Pro.
- A thin conductor (tweezers, wire)
- Screwdriver to open the back panel of the phone.
Read more: Xiaomi MI 2 EDL Mode
How to Connect ISP to EMMC or UFS repair Box
- Firstly, Power Off and disassemble the back cover.
- Then remove the battery, and camera.
- Locate the eMMC or UFS pinout on the motherboard.
- Refer to the pinout image above: TxOp, TxOn, RxOp, and RxOn pins.
- Run UFI box or EMMC box and its ISP adapter.
- Use jumper wires to connect the four pins – TxOp, TxOn, RxOp, and RxOn.
- Connect the USB cable to power the VCC and VCCQ lines.
- Insert the adapter into the UFI box.
- Reconnect the battery to the PCB.
- Now use your EMMC tool software to read or write UFS memory.
Do check: UnlockTool latest setup
Warning:Â Incorrectly shorting test points can damage the Realme 12 5G. Proceed with caution!
